High-quality stainless steel bumper protection for VW Golf 7 Sedan from 2012 until today

High quality stainless steel bumper protection brushed for the rear bumper

The strip protects the bumper from mechanical damage to the upper side, which is used throughout when unloading and loading. In addition, the strip protects the edge of the bumper thanks to the specially profiled bevelling.

Ideal as protection for the bumper or to cover existing scratches.

The bar is mounted over the rear bumper.
Material: Made of high-quality stainless steel (brushed)
Absolutely rustproof
Adhesive strips on the back; fitted in a few minutes
Vehicle-specific, highest fitting accuracy, with folded edge
Stylish and modern look
Visual enhancement of the vehicle rear

Installation instructions:

• Before removing the protective film of the adhesive tape, check whether the load sill protector is intended for the surface to be covered.
• It is important that the surface to be covered is clean, dry and free of grease.
• The load sill protector is attached using the adhesive strips pre-mounted on the back.
• Please ensure that the load sill protector is flush from the start. To position it centrally, you can use the latch on the boot floor as a guide.
• Then press down several times and you're done!