The FOXY Brushed series DC motors are perfect for a wide range of model building applications - for driving airplanes, ships, cars, tanks, and other land vehicles with direct drive and gear. When installing and connecting FOXY Brushed motors, make sure not to exceed the permissible values for supply voltage and current load. Motor cooling: During operation, the temperature of the motor's outer casing should not exceed 80 °C. Therefore, it is always necessary to ensure adequate access for cooling air and its circulation around the motor in the model. For ship models, we recommend using water cooling. High motor loads are only permissible for short periods. After each flight or drive, the motor must cool down to room temperature before restarting. The FOXY 250 7.2 V is a DC electric motor of size "250" with a shaft diameter of 2.0 mm and sliding bearings, suitable for driving indoor airplane models with direct drive (4x3.5" propeller) or with gears, as well as for small car and ship models. To control its speed, you will need an electronic speed controller with a load capacity of 6-8 A. The FOXY 250 7.2 V is a suitable replacement for the SPEED Motor 250 7.2 V. The motor set includes: the FOXY 250 7.2 V motor and the instruction manual 3BD1005.